Zebra ® Zurücksetzen - Boot

Zebra 140Xi4 Factory Reset

1. Press SETUP/EXIT button two times. The LCD will read SAVE CHANGES.
2. Press the INCREMENT (+) button repeatly until LOAD DEFAULTS is displayed.
3. Press the NEXT/SAVE button.
4. The printer has now reset to default, it will perform a self calibration.

Zebra GK420D / GX420D / LP2824 Factory Reset

1. Press and hold the FEED button while you turn on the power, to enter a factory default reset modes
   for printers with a network (Ethernet, Wi-Fi or Bluetooth) printer option.
2. Releasing the button after the first flash resets the network factory options only.
3. Releasing the button after the second flash sequence (two flashes) will reset the printer defaults only.
4. Releasing the button after the third flash sequence (three flashes) will reset both printer and network settings.

Zebra LP2844 Factory Reset

1. Type "Devices and Printers" in the Windows 8 Search box and select
   “Devices and Printers” from the list of search results.
2. Right-click the “Zebra LP 2844” printer and select “Properties” from the drop-down menu.
3. Select the “Printer” tab, which will be the second-to-last tab on the right side of the window.
4. Click on the “+” symbol next to “Advanced” in the main portion of the properties window.
   Then click the “Tools” button that appears.
5. Place the cursor into the “Direct Command For Printer” box. Type in “^default” and then
   click on the “Send” button. Your Zebra printer will now revert back to its factory default settings.

Zebra S600 Factory Reset

1. Press and hold the FEED and PAUSE buttons while turning on the power.
2. Permanently save these values in memory by pressing the MODE button 4 times;
   the DARKEN, POSITION, and CALIBRATE LEDs will flash, indicating the changes have been saved.
3. To return to printing mode, turn off and then turn on the printer.

Zebra TPL2824 / TPL2844 Factory Reset

1. For troubleshooting and to overwrite all stored parameters, send the “^default” command.

Zebra Z4M / Z4M Plus Factory Reset

1. By pressing the SETUP/EXIT key, There are 5 choices, which are described below.
   Pressing the INCREMENT (+) or DECREMENT (–) key displays other choices and
   pressing the SELECT key selects the displayed choice.
    - PERMANENT — Permanently saves the changes.
      Values are stored in the printer even when power is turned off.
    - TEMPORARY — Saves the changes until you change them again or until power is turned off.
    - CANCEL — Cancels all changes from the time you pressed the SETUP/EXIT key
      except for darkness and tear-off settings (if they were changed).
    - LOAD DEFAULTS — Loads factory defaults.
    - LOAD LAST SAVE — Loads values from the last permanent save.

Zebra ZM400 / ZM600 Plus Factory Reset

1. Press SETUP/EXIT button two times. The LCD will read SAVE CHANGES.
2. Press the INCREMENT (+) button repeatly until LOAD DEFAULTS is displayed.
3. Press the NEXT/SAVE button.
4. The printer has now reset to default, it will perform a self calibration.